The short version of amino acid substitution fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-04-21. Anything still debated is marked as such rather than presented as settled.
Verification of a purchased sample requires documentation linking a batch to a certificate of analysis, and that document should be read for the methods used rather than the headline purity figure. A single chromatographic percentage does not establish identity. Independent laboratories can perform identity and content assays, but no such test establishes that a product is suitable for human use. Claims about efficacy rest largely on small, early studies rather than on replicated controlled trials, and that gap remains open.
Identity testing for a cyclic peptide of this size usually relies on reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The mass spectrum confirms molecular weight, while the chromatographic trace indicates the proportion of related impurities. Tandem mass spectrometry can provide sequence-level information when fragmentation data are compared against a reference standard. Nuclear magnetic resonance is sometimes used to confirm the lactam bridge, although it requires more material and greater operator expertise than routine chromatographic methods.
The compound was developed in the late 1980s and 1990s by academic researchers investigating photoprotection. The rationale held that stimulating melanin production might reduce ultraviolet damage to skin and lower skin cancer risk. Early work examined receptor binding, pigment response, and short-term tolerability in small studies. That program did not produce an approved drug, and formal development stalled after early-phase trials. Whether induced pigmentation confers meaningful photoprotection remains an open question.
Outside regulated medicine, melanotan II circulates through online vendors as a research chemical, often marketed for tanning. Products sold this way vary widely in purity, concentration, and labeling accuracy, and independent testing has documented discrepancies. Published reports describe both pigment effects and adverse reactions, including nausea, flushing, and darkening of existing moles. Long-term safety data are sparse, and no large controlled trial has established a risk profile. Questions about cumulative effects on melanocytes remain unresolved in the literature.
Melanotan II is a synthetic peptide analog modeled on alpha-melanocyte-stimulating hormone, a naturally occurring signaling peptide involved in pigmentation. Its structure is a cyclic heptapeptide containing two non-natural substitutions, norleucine at position four and D-phenylalanine at position seven. These modifications resist enzymatic breakdown and extend the molecule's activity relative to the native hormone. The compound binds melanocortin receptors and is studied mainly as a pharmacological tool rather than a therapeutic product. It has never received approval as a medicine in any major jurisdiction.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white solid | Lyophilised cake or flake |
| Solubility class | Soluble in water and aqueous buffer | Also soluble in some polar organic solvents |
| Typical storage temperature | Minus 20 degrees Celsius or below | Desiccated and protected from light |
| Typical analytical method | LC-MS/MS | Reversed-phase separation with mass detection |
| Molecular formula | C50H69N15O9 | Free base; salt forms differ |
Lyophilised melanotan-2 is supplied as a solid, which is more stable than a solution. The material is hygroscopic, so weighing is done quickly, in low humidity, with the container kept sealed. Reconstitution usually uses water for injection or bacteriostatic water, added down the wall of the vial to limit foaming. A reconstituted solution is held at 2 to 8 °C and kept away from light. Repeated freezing and thawing of the same vial is avoided because ice crystal formation and concentration effects degrade the peptide.
Reversed-phase high-performance liquid chromatography is the routine method for purity assessment. Peptides absorb near 214 nm because of the peptide bond, and a gradient of acetonitrile in water separates the intact peptide from deletion sequences, oxidised products, and earlier-eluting fragments at neutral pH. Electrospray ionisation mass spectrometry provides an orthogonal check: the measured mass must agree with the theoretical value. Amino acid analysis and peptide mapping confirm structure but are used less often. Reference standards remain scarce because the peptide is not described in any pharmacopoeia.
Two structural changes distinguish the synthetic peptide from the natural hormone. A norleucine residue replaces methionine at one position, and a D-configured phenylalanine replaces the natural L-form at another. Both substitutions slow enzymatic breakdown, which extends the molecule's persistence relative to the parent hormone. The lactam bridge further constrains the backbone into a stable conformation. These features are standard design strategies in peptide chemistry and are not unique to this compound; they appear across many research peptides built for improved stability.
The compound was developed in the late 1980s and early 1990s by academic researchers investigating melanocortin signaling and pigmentation. Early work explored whether synthetic analogs could reproduce effects of the natural hormone under controlled conditions. The molecule never advanced through the full regulatory pathway required for approval as a medicine. From the mid-2000s onward it appeared in unregulated consumer markets, often distributed through informal channels. That gap between research origins and commercial availability shapes how the compound is discussed today.
Melanotan-2 is a synthetic peptide designed as an analog of alpha-melanocyte-stimulating hormone, a signaling molecule produced in the pituitary and skin. Its structure is a linear chain of seven amino acids that folds into a ring through an internal lactam bridge joining two side chains. The compound is sometimes written as MT-II or MEL-2 in informal and commercial contexts. It belongs to the melanocortin peptide family, a group of short signaling molecules that share a conserved core sequence recognized by melanocortin receptors.
Reported observations after unregulated use include shifts in skin pigmentation and, in some accounts, unintended changes to moles and other lesions. Whether these outcomes are causally linked to the compound, and how often they occur, remain open questions because controlled data are scarce. The absence of standardised dosing and verified product purity complicates interpretation. Researchers have called for better surveillance and analytical characterisation of samples obtained outside regulated channels. Conclusions drawn from anecdotal evidence should be treated as provisional.
Melanotan-2 has not received marketing authorisation from major regulatory agencies for any therapeutic indication. Several jurisdictions classify it as a prescription-only medicine or a controlled substance when supplied for human use. Because approved products do not exist, material sold online usually sits outside pharmaceutical supply chains and formal quality oversight. Regulators have issued public notices describing the compound as unapproved. Enforcement varies, and the legal position differs between countries, which complicates any single general statement about its status.
Scientific discussion of Melanotan-2 spans pharmacology, dermatology, and public-health literature. Laboratory studies examine its receptor binding and cellular effects, while clinical reports describe outcomes observed after unregulated use. These two bodies of work differ in rigour and intent. Peer-reviewed trials of the compound as a medicine are limited, so much of the available information comes from case reports and surveillance data. Authors frequently note the gap between experimental findings and real-world use.
== Derived units and SI multiples == The only SI derived unit with a special name derived from the mole is the katal, defined as one mole per second of catalytic activity. Like other SI units, the mole can also be modified by adding a metric prefix that multiplies it by a power of 10:
The three substrates of this enzyme are formaldehyde, oxidised nicotinamide adenine dinucleotide (NAD+), and water. Its products are formic acid, reduced NADH, and a proton. This enzyme belongs to the family of oxidoreductases, specifically those acting on the aldehyde or oxo group of donor with NAD+ or NADP+ as acceptor. The systematic name of this enzyme class is formaldehyde:NAD+ oxidoreductase. Other names in common use include NAD+-linked formaldehyde dehydrogenase, s-nitrosoglutathione reductase (GSNO reductase) and NAD+-dependent formaldehyde dehydrogenase. This enzyme participates in methane metabolism.
Microplastic is a type of airborne particulates and is found to prevail in air. A 2017 study found indoor airborne microfiber concentrations between 1.0 and 60.0 microfibers per cubic meter (33% of which were found to be microplastics). Airborne microplastic dust can be produced during renovation, building, bridge and road reconstruction projects and the use of power tools.
PCB-exposed females kept their color longer than they should have. Normally, loss in color is associated with carotenoids being directed to ovaries to help in egg development. PCB-exposed females retained their colors longer, suggesting the PCBs made them less prepared for reproduction. The same females also had significant delays in egg laying. Offspring also showed higher incidence of developmental problems and decreased reproductive success. PCBs have also been found to affect eye color in American Kestrels. Eye color in kestrels is known to vary with age and sex, however, when exposed to PCBs, color patterns were suppressed regardless of age and sex. While it is unknown what role eye color plays in visual acuity, this may be of greater concern to birds like kestrels who rely heavily on vision for hunting. PDBEs were linked to changes in breeding behavior in kestrels as well. Different levels of PDBE exposure were linked to different changes in behavior as well. Overall, PDBE exposure led to changes in behaviors that strengthen the bond between a breeding pair. Such behaviors include frequent copulation, food transfers, male posturing, nest box inspection, and specific mating calls (7). High exposure levels led to increases in some behaviors and decreases in some, whereas low exposure caused decreases in almost all behaviors observed. PDBE exposure also altered the timing of these behaviors, often delaying them by several days when compared to the control group. American Kestrels have also been used extensively in toxicology research.
Sources: en.wikipedia.org
== Applications == Owing to its scarcity, high price and radioactivity, 227Ac currently has no significant industrial use, but 225Ac is currently being studied for use in cancer treatments such as targeted alpha therapies. 227Ac is highly radioactive and was therefore studied for use as an active element of radioisotope thermoelectric generators, for example, in spacecraft. The oxide of 227Ac pressed with beryllium is also an efficient neutron source with the activity exceeding that of the standard americium-beryllium and radium-beryllium pairs. In all those applications, 227Ac (a beta source) is merely a progenitor which generates alpha-emitting isotopes upon its decay. Beryllium captures alpha particles and emits neutrons owing to its large cross-section for the (α,n) nuclear reaction:
is the concentration of the solid in the diffusion layer surrounding the solid. D is the diffusion coefficient. L is the diffusion layer thickness. As can be inferred from the Noyes–Whitney equation, the rate of dissolution may be modified primarily by altering the surface area of the solid by altering the particle size (e.g., with micronization). For many drugs, reducing the particle size reduces the dose needed to achieve the same therapeutic effect. The particle size reduction increases the specific surface area and the dissolution rate and does not affect solubility. The rate of dissolution may also be altered by choosing a suitable polymorph of a compound. Different polymorphs have different solubility and dissolution rate characteristics. Specifically, crystalline forms dissolve slower than amorphous forms since they require more energy to leave the lattice during dissolution. The stablest crystalline polymorph has the lowest dissolution rate. Dissolution also differs between anhydrous and hydrous forms of a drug. Anhydrous forms often dissolve faster but sometimes are less soluble. Esterification is also used to control solubility. For example, stearate and estolate esters of drugs have decreased solubility in gastric fluid. Later, esterases in the gastrointestinal tract (GIT) wall and blood hydrolyze these esters to release the parent drug. Coatings on a tablet or pellet may act as barriers to reducing the dissolution rate. Coatings may also be used to control where dissolution takes place.
Official state government portal Geographic data related to Schleswig-Holstein at OpenStreetMap Chisholm, Hugh, ed. (1911). "Schleswig-Holstein" . Encyclopædia Britannica (11th ed.). Cambridge University Press. Schleswig-Holsteins Ehrenbürgerinnen und Ehrenbürger (Schleswig-Holstein Honorary Citizens, In German)
Sources: en.wikipedia.org
Mass spectrometry combined with liquid chromatography provides both molecular weight confirmation and a measure of related impurities. Tandem mass spectrometry adds sequence information. A purity percentage reported without a mass measurement does not confirm what the material is.
No. Lyophilisation slows degradation rather than stopping it, and the rate depends on residual moisture, temperature and light exposure. Freezer storage extends useful life but does not make the material permanent.
A certificate is only as good as its traceability to a specific batch and a named laboratory. Documents lacking batch numbers, method descriptions or laboratory identifiers carry little weight. Confirming what was actually received generally requires a separate test of the material in hand.
It is a synthetic cyclic peptide designed as an analog of alpha-melanocyte-stimulating hormone. It acts on melanocortin receptors and is best known from research into pigmentation. It is not an approved pharmaceutical product.